Page of 8
LOG SETTING:
Ensure the log is fixed in a vise, clamp, or fixture with a V-shaped notch. Timber Tuff’s TMW-77 Log
Vise is the perfect tool for this.
CAUTION:
If the log becomes loose and is not fixed when cutting the tenon, DO NOT drop the drill or try to catch
or grab the log. Stop the drill and remove it from the end of the log. Assemble the log again to ensure its
stabilization.
Obtain the log you want to tenon. Cut it to length and make sure the ends are flat. If the ends are not
flat, the tenon will be crooked.
If the log diameter is larger than the tool can handle, taper the end with a draw shave. See above.
To Next Page
Loading...
