What to do if my Timberk Air Conditioner shows error E4?
If your Timberk Air Conditioner displays 'E4', it means the water tank is full or the plug isn't correctly connected. To fix this, remove the rubber plug at the bottom of the unit to drain the water. After draining, double-check that the plug is properly connected.
Why is my Timberk AC TIM 09H P4 Air Conditioner not turning on?
Your Timberk Air Conditioner might not be turning on because the condensate collection tray is full, as indicated by a flashing tank fill-up indicator. Empty the water from the tray. Alternatively, if you're in heating mode, the room temperature might be higher than the set temperature. Adjust the temperature setting accordingly.
Why does my Timberk AC TIM 09H P4 switch to heating mode?
The Timberk Air Conditioner switches to heating mode because automatic overheating protection has been activated. This happens when the outlet air temperature exceeds 70°C. To resolve this, wait for the air conditioner to cool down before turning it back on.
What to do if my Timberk Air Conditioner is not switched on when I press the Power button?
If your Timberk Air Conditioner doesn't turn on, it might be due to the condensate collection tray being full, which causes the tank fill-up indicator to flash. In this case, you should drain water from the tray. Another reason could be that the actual room temperature is higher than the set temperature in heating mode. To solve this, set the temperature correctly.
Why does my Timberk AC TIM 09H P4 switch off in heating mode?
Your Timberk Air Conditioner might be switching off in heating mode because the automatic overheating protection has been tripped. This happens when the outlet air temperature exceeds 70°C. Allow the air conditioner to cool down before switching it on again.
What does E3 error mean on my Timberk Air Conditioner?
The E3 error code on your Timberk Air Conditioner indicates that the tank is filled up with water or the plug is connected incorrectly. Remove the rubber plug, located at the bottom of the unit, and drain the water. Then, check if the plug is connected correctly.
Why is my Timberk AC TIM 09H P4 Air Conditioner making a loud noise or strong vibration?
Loud noise or strong vibration from your Timberk Air Conditioner usually means it's installed on an inclined or uneven surface. Make sure to install the air conditioner on a smooth, horizontal surface.
Why does my Timberk AC TIM 09H P4 make a noise resembling a gurgle of water?
If your Timberk Air Conditioner is making a gurgling water noise, it's likely due to the refrigerant flowing through the pipes. This is normal.
Instructions for correctly installing the air outlet hose.
Steps to connect the hose for different operating modes.
Procedure for cleaning the device's air filter.
Guide for cleaning the heat exchangers and the appliance body.
Explanation of how condensate is automatically removed.
General| Type | Split-system |
|---|---|
| Cooling Capacity | 9000 BTU/h |
| Heating Capacity | 9500 BTU/h |
| Cooling area | up to 25 m² |
| Power Consumption (Cooling) | 820 W |
| Energy Efficiency Class (Cooling) | A |
| Energy Efficiency Class (Heating) | A |
| Refrigerant | R410A |
| Noise Level (Outdoor) | 50 dB |
| Weight (Indoor Unit) | 8 kg |
| Weight (Outdoor Unit) | 25 kg |
| Operating Temperature (Cooling) | 18-43°C |
To Next Page
