Timberk T-PAC07-P12E User Manual (English)

Questions and Answers:

J
Jennifer HansonAug 12, 2025
Why Timberk Air Conditioner cooling effect is not good?
- B
  Brooke HernandezAug 13, 2025
  Several factors can impact the cooling performance of your Timberk air conditioner. Direct sunlight can hinder cooling, so try pulling the curtains. Open doors or windows, a crowded room, or other heat sources can also reduce effectiveness; close any openings and consider adding another air conditioning unit. A dirty filter screen or blocked air inlet/outlet could also be the cause; clean or replace the filter and clear any obstructions.
K
kennethromeroAug 16, 2025
What to do if my Timberk T-PAC07-P12E Air Conditioner remote control does not work?
- M
  Michelle EstesAug 16, 2025
  If your Timberk air conditioner's remote control isn't working, first ensure you're close enough to the unit and that the remote is pointed directly at the receiver. Also, check the batteries and replace them if they're dead.
J
Joseph WoodAug 20, 2025
What to do if Timberk T-PAC07-P12E Air Conditioner compressor does not work?
- S
  Stephanie VasquezAug 20, 2025
  If the compressor of your Timberk air conditioner isn't working, it might be due to overheat protection being activated. Wait for approximately 3 minutes to allow the temperature to decrease, and then attempt to restart the unit.
R
reyeslindaAug 25, 2025
How to fix a Timberk Air Conditioner that is making a big noise?
- J
  Jasmine FoleyAug 25, 2025
  If your Timberk air conditioner is making excessive noise, ensure it is placed on a flat, hard surface. This should help reduce the noise level.
J
Jason FinleyAug 27, 2025
What to do if my Timberk T-PAC07-P12E displays 'E1'?
- L
  Laura ShermanAug 27, 2025
  If your Timberk air conditioner is displaying 'E1', it indicates an issue with the room temperature indicator. Check the room temperature indicator, looking for any disconnected contact assemblies.
A
Angie TownsendAug 31, 2025
What to do if my Timberk T-PAC07-P12E displays 'E2'?
- S
  Seth RossAug 31, 2025
  If your Timberk air conditioner displays 'E2', this indicates an abnormality with the pipe room temperature. Check the pipe temperature sensor for failure; replacement may be required.
A
Amanda GarrettSep 4, 2025
What to do if Timberk T-PAC07-P12E overflow indicator displays "FL"?
- L
  Lauren EdwardsSep 4, 2025
  If the overflow indicator on your Timberk air conditioner displays "FL", you need to discharge the water inside the unit.
J
Johnny MercerSep 7, 2025
What to do if Timberk Air Conditioner is in dehumidification mode and the ambient temperature is low?
- T
  Tina EllisSep 7, 2025
  To use your Timberk air conditioner's dehumidification mode effectively, ensure the machine is placed in a room with an ambient temperature greater than 17 °C (62 °F).

Timberk T-PAC07-P12E Specifications

General

Noise Level	54 dB
Refrigerant	R410A
Dehumidifying Capacity	1.2 L/h
Timer	Yes
Remote Control	Yes
Air Flow (High)	350 m³/h
Power Supply	220-240 V, 50 Hz
Cooling Capacity	7000 BTU/h
Operating Temperature (Cooling)	16-32 °C
Type	Portable Air Conditioner
Cooling Area	20 m²
Dimensions (Indoor Unit)	710 x 250 x 190 mm