Daily Maintenance
Daily Maintenance
• Check all nuts, bolts, and welds to be sure that the frame and components are secure
• Make sure that the wear plates attached to the wedge assembly are fi rmly bolted in place
• Make sure wedge assembly and top of beam are well lubricated with grease
• Grease push block at grease fi ttings
• Smear grease across top of beam
• Inspect hydraulic hoses for frayed, worn, kinked, or abraded areas
• Replace any damaged or worn hydraulic hoses immediately
General
Grease
Hydraulic Hoses
Make sure system is depressurized before you do any hydraulic system repairs.
See Hydraulic Safety in the Safety section.
WARNING
23
TIMBERWOLF FIREWOOD PROCESSING EQUIPMENT
To Next Page
