1
1. General Information
These instructions should be read carefully and retained for further reference
and maintenance.
2. Safety
• Before installation or maintenance, ensure the mains supply to the luminaire
is switched off and the circuit supply fuses are removed or the circuit breaker
turned off.
• It is recommended that a qualified electrician is consulted or used for the
installation of this luminaire and install in accordance with the current IEE
wiring and Building Regulations.
• Check that the total load on the circuit including when this luminaire is fitted
does not exceed the rating of the circuit cable, fuse or circuit breaker.
3. Technical Specifications
• 230V AC 50Hz
• This luminaire is of class I construction and must be earthed
• 2x 10W LED Non replaceable lamp
• Energy Usage: 20KwH/1000H
• Lumen Output: 2x 840lm
• Motion Detection Range: Up to 10m at 2.5m mounting height
• Detection Angle: 180°
• Lamp Adjustment Pan and Tilt: Wall Mount – Pan Outward 21° (limited by wall),
Pan Inward 45°, Downward 70°
Wall Mount with Spacer (sold separately) –
Pan Outward 40° (limited by wall),
Pan Inward 45°, Downward 70°
Inner Corner Bracket (sold separately) –
Pan Inward from 10° to 45° (limited by wall),
Downward 70°
Outer Corner Bracket (sold separately) –
Pan Outward 45°, Pan Inward 45°,
Downward 70°
• Time ON Adjustment: 2 seconds to 30 minutes
(2s, 20s, 2m, 5m, 10m, 15m, 30m)
To Next Page
Loading...
Need help?
General