16
Quick Programming Tips
• Up to 6 timed temperature periods are allowed per day.
• They can be edited or deleted by holding the time or temperature.
• If there are less than 6 periods, new periods can be added using the + key.
• The active repeats are shown in dark blue and active days for other pages
are shown in turquoise.
• Days can be selected and deselected by touching the day required.
• The dots or grey squares show the number of pages, with the bold square
being the active page.
• If a day is de-selected, it shows grey; this would mean that the programme
last will continue to run until the next active day with a programme
takes over.
• If there are grey days, a new page can be added using the + page button.
If there are no grey days, new pages cannot be added because all the days
would be active on one of the pages from that programme set.
• If individual day programming is required, this can be achieved by having
only one active day per page until no additional pages can be added.
(Page 1 M, Page 2 Tu, Page 3 W, Page 4 Th) etc.
Note: On exiting programming, any days that are grey will be
deleted. Days cannot be left inactive. If a day is missing, the last
temperature set will be active until the next programmed day.
Resetting the Thermostat
• Put the thermostat into couple mode, (see page 8). Press + or - to see the
following menu options; Couple, Time entry, programming, copy, technical,
and reset. Press set to select.
• Technical can be used to re-calibrate the displayed temperature.
• It is recommended that the Programastat+ App is used to perform all
programming operations, but changes made here at the thermostat
will be reflected in the App on your phone.
To Next Page
Loading...
Need help?
General
