9
Wake To Radio
1. Turn the radio ‘On’ and select the band, station, and volume level that you wish to hear when the alarm comes ‘On’,
then turn the radio ‘Off’ again.
2. Reconfirm the wake-up time and alarm mode settings for the alarm you are using, Alarm 1 or Alarm 2, or both alarms.
3. Slide the ALARM SELECTOR control on the front panel for one or both alarms to the Radio position. The appropriate
AL 1 and/or AL 2 indicators will light up to confirm that the alarms are set.
4. At the selected wake-up time the radio will turn ‘On’. It will play for one hour and then shut off automatically.
5. To stop the radio sooner, press either the appropriate ALARM 1 or ALARM 2 button, or press the RADIO ON/OFF
button. The radio will stop but the alarm remains set and will turn on again at the same time on the following day,
depending on the Alarm Mode setting.
6. If you do not want the alarm to repeat on the following day, slide the appropriate ALARM SELECTOR switch to the
‘Off’ position. The AL 1 and/or AL 2 indicators turn off.
Wake To Soothing Sounds
1. Turn the radio ‘On’, set the AM/FM/SOUNDS selector to the SOUNDS position, select the desired sound, and adjust
the VOLUME control as desired. Then turn the radio ‘Off’ again.
2. Reconfirm the wake-up time and alarm mode settings for the alarm you are using, Alarm 1 or Alarm 2, or both alarms.
3. Slide the ALARM SELECTOR control on the front panel for one or both alarms to the Radio position. The appropriate
AL 1 and/or AL 2 indicators will light up to confirm that the alarms are set.
4. At the selected wake-up time the selected sound will turn ‘On’. It will play for one hour and then shut off automatically.
5. To stop the sound sooner, press either the appropriate ALARM 1 or ALARM 2 button, or press the RADIO ON/OFF
button. The sound will stop but the alarm remains set and will turn on again at the same time on the following day,
depending on the Alarm Mode setting.
6. If you do not want the alarm to repeat on the following day, slide the appropriate ALARM SELECTOR switch to the
‘Off’ position. The AL 1 and/or AL 2 indicators turn off.
Wake To Buzzer (Crescendo Alarm)
Note: Alarm 1 and Alarm 2 have different buzzer sounds.
• Alarm 1 is a “Single Beep” sound.
• Alarm 2 is a “Double Beep” sound.
You will be able to tell which alarm is going off by the sound that it makes.
1. Reconfirm the wake-up time and alarm mode settings for the alarm you are using, Alarm 1 or Alarm 2, or both alarms.
2. Slide the ALARM SELECTOR control on the front panel for one or both alarms to the Buzz position. The appropriate
AL 1 and/or AL 2 indicators will light up to confirm that the alarms are set.
3. At the selected wake-up time the buzzer will turn ‘On’. It will continue for one hour and then shut off automatically.
4. To stop the buzzer sooner, press the appropriate ALARM 1 or ALARM 2 button. The buzzer will stop but the alarm
remains set and will turn on again at the same time on the following day, depending on the Alarm Mode setting.
5. To stop the buzzer and turn the radio ‘On’ immediately, press the RADIO ON/OFF button instead of the ALARM 1
and ALARM 2 button.
6. If you do not want the alarm to turn the buzzer on the following day, set the appropriate ALARM selector to the ‘Off’
position.
To Next Page
Loading...
Need help?
General
