Instructions for Use
1. Please consult with a licensed electrician prior to installation
of the Helios 4. High voltage can be dangerous!
2. Connect 240 volt power to the 3 screws under the protec-
tive cover. (See ‘Instructions for Operation’ section).
3. Replace protective cover with screws provided.
4. Securely mount your Helios 4, with hardware provided,
near the ballasts to be operated. It should be placed away
from water, mist, spray, etc.
5. Plug your ballasts into the outlets on the left and right side
of the controller.
6. Plug the relay activation cord set into Apollo Series
wall timer.
7. Turn on Helios 4 power switch to activate
lighting controller.
8. Your Helios 4 will now control your ballasts at the
desired settings until the power is defeated.
Helios 4 TM
4 Light - 240 Volt Lighting Controller
Easy Guide
VANCOUVER, WASHINGTON U.S.A.
®
Controller Specifi cations
Size: 11”H x 11”W x 4”D
Weight: 4 lbs.
Voltage Input: 240 volts
Voltage Output: 240 volts
Maximum Amperage: 30 amps
Maximum Wattage: 4000 Watts
Hertz: 60 Hz
Time switch: 120 Volt relay trigger cord set
Operating Temperature: 40
o
to 125
o
F | 5
o
to 52
o
C
Storage Temperature: 32
o
to 135
o
F | 0
o
to 57
o
C
to 30 Amp
Power Source
120 Volt
to 120 Volt
Timer
Fan
to 240 Volt Ballast
to 240 Volt Ballast
Sun System
R
Sun System
R
to 240 Volt Ballast
to 120 Volt
Timed Outlet
to 240 Volt Ballast
Helios 4
240 Volt
Sun System
R
Sun System
R
Titan Apollo
24 HR
Timer
Wiring
diagram
Hot
NeutralGround
Hot
Controlling a light bank
®
www.titancontrols.net
For technical assistance call us at
1-888-80-Titan or 1-888-808-4826.
To Next Page
Need help?
General
