How to clean the inlet filter on a Titan ControlMax 1900 Pro when the spray pattern is distorted?
If the Titan Paint Sprayer's spray pattern becomes distorted or stops spraying while triggered due to a clogged inlet filter, remove the inlet filter from the suction tube. Clean the filter screen using warm, soapy water for latex materials, or mineral spirits for oil-based materials. Then, snap the inlet filter back into place.
Details proper grounding procedures for electrical safety.
Hazards related to flammable vapors and ignition sources.
Risks of serious injury from high-pressure paint streams.
Health risks from inhaling or contacting hazardous vapors.
General warnings for severe injury or property damage.
Guidelines for safe and effective use of extension cords.
Steps to safely relieve pressure in the system.
Steps to clear a clogged spray tip.
Steps to clean a clogged inlet filter.
Common issues, causes, and solutions for sprayer operation.
Details proper grounding procedures for electrical safety.
Hazards related to flammable vapors and ignition sources.
Risks of serious injury from high-pressure paint streams.
Health risks from inhaling or contacting hazardous vapors.
General warnings for severe injury or property damage.
Guidelines for safe and effective use of extension cords.
Steps to safely relieve pressure in the system.
Steps to clear a clogged spray tip.
Steps to clean a clogged inlet filter.
Common issues, causes, and solutions for sprayer operation.
General| Brand | Titan |
|---|---|
| Model | ControlMax 1900 Pro |
| Category | Paint Sprayer |
| Language | English |
To Next Page