How to clean the inlet filter on a Titan ControlMax 1700 Paint Sprayer when the spray pattern is distorted?
If the Titan Paint Sprayer's spray pattern becomes distorted or stops spraying while triggered due to a clogged inlet filter, remove the inlet filter from the suction tube. Clean the filter screen using warm, soapy water for latex materials, or mineral spirits for oil-based materials. Then, snap the inlet filter back into place.
General| Type | Airless Paint Sprayer |
|---|---|
| Max Flow Rate | 0.34 GPM |
| Hose Length | 50 ft |
| Spray Pattern | Adjustable |
| Power Source | Electric |
| Flow Rate | 0.34 GPM |
| Spray Tips Included | 515 |
| Tip Size | 0.017 in |
| Power | 0.60 HP |
Details the importance and procedure for grounding the electrical equipment.
Covers specific dangers like explosion, fire, and injection injuries during operation.
Highlights risks of flammable vapors and ignition sources.
Warns about high-pressure streams causing severe skin injury or amputation.
Addresses dangers from inhaling or contacting harmful paints and solvents.
Details the critical steps to safely release system pressure before maintenance.
To Next Page