5
Preparations For Use
Installing Inner Pile Head
If the inner pile head (#49) is not pressed on the shock (#43) at this time, you must slide the inner pile head inside
the piling socket and match the small side with the shock. Tap the inner pile head a few times to make sure it is
connected to the shock. As you start using your machine, the inner pile head will press further on the shock and will
not separate again without the use of tools.
Adding Fuel
1. Always turn the engine off and allow adequate time for it to cool before refueling. Only use unleaded
fuel with 86 octane or higher.
2. Never refuel your driver with the engine hot, running, or in an unventilated area. Fuel vapors are
extremely flammable and can cause severe injury or death if ignited by a spark or excessive heat
from a hot
engine.
3. Do not add too much fuel. The fuel level should not exceed the neck of the filler fuel tank. If
accidental overfilling occurs, pour fuel out until the fuel level is within the proper range within the fuel
tank. There should not be any fuel on the surface of the machine. ALWAYS wipe your post driver
clean after refueling. Only start the post driver after any excess fuel has evaporated completely.
4. After refueling, tighten the fuel tank lid.
5. This post driver uses pure gasoline as fuel. Do not use gasoline mixed with oil. This will result in poor
starting performance and low function.
Before use, install the correct piling socket sleeve for your application as shown below:
Installing Piling Socket Sleeve
To Next Page
Loading...
Need help?
General
