8
TT5MTP26-2
Getting Started . . .
Transport and storage
> Stop the engine before transporting the machine.
>
Carry the machine by the handle with the engine off. Handling the machine properly
reduces the possibility of personal injury.
> Ret the transport guard on the cutting attachments (cutting blade and saw chain)
during transportation or storage.
> Allow the engine to cool before storing in any enclosure.
> Never store the machine with petrol in the tank inside a building where fumes can
reach an open ame or spark.
>
Store the machine and fuel so that there is no risk of leakages or fumes coming
into contact with sparks or naked ames from electrical equipment, electric motors,
relays/switches, boilers etc.
>
Empty machine of fuel after every use. Run the machine dry of fuel in idle before
storage.
>
Dispose of waste oil and fuel at a local petrol station, local authority centre or where
facilities exist.
Vibration and noise reduction
To reduce the impact of noise and vibration emission, limit the time of operation, use
low-vibration and low-noise operating modes as well as wear personal protective
equipment.
Take the following points into account to minimise the vibration and noise exposure risks:
> Only use the machine as intended by its design and these instructions.
> Ensure that the machine is in good condition and well maintained.
> Use correct attachments for the machine and ensure they are in good condition.
> Keep a tight grip on the handles/gripping surfaces.
>
Maintain this machine in accordance with these instructions and keep it well lubricated
(where appropriate).
>
Plan your work schedule to spread any high vibration tool use across a longer period
of time.
Safety information
To Next Page
Loading...
Need help?
General
