JIG SAW 750W TTB285JSW
OPERATIONS INSTRUCTIONS
Note: Before using the tool, read the instruction
book carefully.
INTENDED USE
This jigsaw shall be used for cutting metal or wood or
similar materials.
Other uses for the tool will lead to the damage of the tool
and a series of dangers to the operator. This tool is
intended for DIY home use, or occasional professional use.
1. Fitting the Saw Blade (Fig. 1)
WARNING. Switch off the jigsaw and unplug from
power point before fitting blades.
Note: When changing blades, set pendulum action
switch to “0”.
Your jigsaw is equipped with a toolfree blade holder. To
open the blade holder, push the ring (jigsaw upside
down) and hold in position. Then fully insert the blade
into the blade holder slot with blade teeth facing
forward and release the ring, which will clamp over the
top of the blade. Push the blade into the blade holder
again to ensure it is locked in position. Ensure the edge
of the blade is located in the groove of the support
roller. To remove blade, hold the blade and push the
ring then lift out the blade.
Warning:
- Blade teeth are very sharp.
- For best cutting result , ensure you use a blade
suited to the material and cut quality you need.
Fig. 1
0
1
2
3
100816_TTB285JSW_Jig Saw-EN-08.pdf 11 8/16/10 2:04 PM
To Next Page
Loading...
Need help?
General
