Titan TTB671VAC - Troubleshooting Guide

TTB671VAC by TITAN
28
EN
In more detail...
EN
Care and maintenance / Troubleshooting
Transportation
> Switch the product off and disconnect it from the power supply before
transporting it anywhere.
> Switch off the attached power tool and disconnect it from the power tool
adaptor if using the product as a dust extraction device.
> Attach transportation guards, if applicable.
>
nozzle head during transport.
> Protect the product from any heavy impact or strong vibrations which may
occur during transportation in vehicles.
> Secure the product to prevent it from slipping or falling over.
Troubleshooting
themselves. Therefore check the product using this section. In most cases the
problem can be solved quickly.
WARNING! Only perform the steps described within these instructions!
All further inspection, maintenance and repair work must be performed
cannot solve the problem yourself!
Problem Possible cause Solution
1. Product does not
start
1.1 Not connected to
power supply
1.2 Power cord or plug
is defective
1.3 Other electrical
defect to the
product
1.1 Connect to power
supply
1.2 Check by a
specialist electrician
1.3 Check by a
specialist electrician
2. Product does not
reach full power
2.1 Extension cord not
suitable for operation
with this product
2.2 Power source (e. g.
generator) has too
low voltage
2.3 Air vents / air inlet is
blocked
2.1 Use a proper
extension cord
2.2 Connect to another
power source
2.3 Clean the air vents /
air inlet