Titan TTB671VAC - Recycling and Disposal

TTB671VAC by TITAN
EN
29
In
more
detail...
EN
Troubleshooting / Recycling and disposal
Problem Possible cause Solution
3. Unsatisfactory result 3.1 Attachment not
suitable for working
surface
3.2 Brush mode is not
proper (combination
brush)
3.3 Dust bag is full
3.4 Suction power is on
a low setting
3.5 Attachment / suction
tube / hose not
properly connected
3.6 Attachment / suction
tube / hose / handle
/ intake blocked or
defect
3.1 Use proper
attachment
3.2 Check and adjust the
brush switch
3.3 Replace with a new
one
3.4 Check and re-adjust
the suction power
control
3.5 Check and re-
connect
3.6 Remove the
blockage or replace
with a new one
4. Strong dust
formation
4.1
worn
4.2
not properly attached
4.3 Attachment / suction
tube / hose / handle /
intake defected
4.1 Replace with a new
one
4.2 Check and re-attach
properly
4.3 Replace with a new
one
5. Excessive vibration
or noise
5.1 Attachment / suction
tube / hose not
properly connected
5.2 Bolts / nuts are
loose
5.1 Check and re-
connect
5.2 Tighten bolts/nuts
Recycling and disposal
WEEE symbol. Waste electrical products should not be disposed of
with household waste. Please recycle where facilities exist. Check
with your Local Authority or local store for recycling advice.
The product comes in a package that protects it against damage
during shipping. Keep the package until you are sure that all parts
have been delivered and the product is working properly. Recycle
the package afterwards.