Getting started...
EN
18
In more detail...
Product functions
Intended use
This air compressor TTB797CPR is designated with a nominal power of 1.5HP
/1200Watts.
This product is intended for generating and supplying compressed air to
pneumatic power tools and tyres. Connect only attachment tools which
maximum air consumption is less than the air output of this product.
operation.
For safety reasons it is essential to read the entire instruction manual before
This product is intended for private domestic use only, not for any commercial
trade use. It must not be used for any purposes other than those described.
Safety features
Safety valve
Overload protection
The motor of this product is equipped with an overload protection. When the
motor is over limit temperature 140℃, the product stops automatically.
> Press the on / off switch (4) to its off position O to switch the product off, and
then disconnect plug from the power supply.Turn the pressure regulator (2)
counter clockwise to stop the air flow to the quicklock coupling (14).
> Disconnect the product from the power supply and let it cool down for
10 minutes.
> Carefully release the remaining pressure in the attachment tool by operating it
until no airflow can be heard.and disconnect it from the quick-lock coupling (14).
Remove the cause of the overload.
> Reconnect the attachment tool to the quick-lock coupling. Ensure the
connection is secured.
WARNING! Make sure the on / off switch (4) is set to its off position O
and then insert the plug into a properly installed socket.
> Reconnect the product to the power supply and press the on / off switch (4)
to its on position I.
> Perform a test for about 2 minutes and 30 seconds to ensure the product runs
smoothly before continuing further operation. If you cannot switch the product
on, see chapter “Troubleshooting”.
4/19/17 4:36 PM
EN
TTB797CPR
by TITAN
In the event that the pressure inside the vessel exceeds the maximum allowable
pressure level, the safety valve is activated. Once the pressure drops down to
To Next Page
Loading...
