Getting started...
EN
20
In more detail...
Operation
General operation
> Check the product, its power cord and plug as well as accessories for damage
before each use. Do not use the product if it is damaged or shows wear.
>
> Ensure that the air vents are always unobstructed and clear. Clean them if
necessary with a soft brush. Blocked air vents may lead to overheating and
damage the product.
> Switch the product off immediately if you are disturbed while working by other
people entering the working area. Always let the product come to complete
stop before averting.
> Do not overwork yourself. Take regular breaks to ensure you can concentrate
on the work and have full control over the product.
WARNING! Several parts such as the cover (3) become very hot
during operation! Be careful when using this product and avoid
contact with hot surfaces – danger of burns.
Attachment tools
This product is delivered with attachment tools.
4/19/17 4:36 PM
EN
TTB797CPR
by TITAN
4
Fig. 5
Fig. 6
Fig. 7
Washing gun Spray gun Inflating gun Air hose PTFE
tape
Quick-lock
coupling
Air duster
operation pressure
30-55 psi (2-3.7bar)
operation pressure
45-75psi (3.1-5.1bar)
operation pressure
45-55 psi (3.1-3.7bar)
gauge 0-150psi
(0-10.3bar)
size 5x8mmx5m
NOTE: The Pressure gauge is not calibrated. It is recommended to
use a
Switching on / off
> Press the on / off switch (4) to its on position I to switch the product on (Fig. 5).
> Press the on / off switch (4) to its off position O to switch the product off (Fig. 6 ).
To Next Page
Loading...
