Getting started...
EN
22
In more detail...
Operation / Care and maintenance
Releasing pressure in the cylinder
After use
> Switch the product off and disconnect it from the power supply.
> Disconnect the attachment tool, if necessary.
> Turn the pressure gauge (1) counterclockwise all the way and let the product
cool down.
> Check, clean and store the product as described below.
> Refer to Releasing pressure in the cylinder process above.
The golden rules for care
4/19/17 4:36 PM
EN
TTB797CPR
by TITAN
>
tool from the product.
NOTE:
it is recommended to switch the product on before connecting it to
>
items, such as tyres.
>
> Switch the product on and wait until it stops, then turn the pressure regulator to
adjust pressure to required level.
> When the desired pressure has been reached, switch the product off.
> Switch off the tool.
> Insert Air Hose with Air Duster Attached.
> With the tool off, turn the outlet pressure regulator to display an output pressure
on the gauge.
> Operate the Air Duster to release pressure in the cylinder.
> Continue to operate air duster until no further air can be heard escaping.
> Disconnect the air hose and duster.
> Return the pressure regulator to the minimum position.
> Disconnect the attachment tool as described above.
WARNING! Always check the compatibility between the product and
the desired pressure!
Do not operate the product in a dusty environment. There is a risk of
Never leave the product running unattended. It can burst car tyres
To Next Page
Loading...
