Getting started...
EN
23
In more detail...
Care and maintenance
WARNING! Drain the condensation water from the pressure
vessel (6) after each use!
Always switch the product off and disconnect it from power supply
before attaching / removing any accessories!
Release all the pressure in the vessel before opening the drain
valve (10).
Maintenance
Before and after each use, check the product and accessories (or attachments)
for wear and damage. If required, exchange them for new ones as described in
this instruction manual. Observe the technical requirements.
4/19/17 4:36 PM
EN
TTB797CPR
by TITAN
Condensation water
Condensation water accumulates inside the pressure vessel during use as a
natural by-product of operation. Accumulation of condensation water can cause
internal corrosion and result in safety hazards.
NOTE: Do not use chemical, alkaline, abrasive or other aggressive
detergents or disinfectants to clean this product as they might be
harmful to its surfaces.
> Check for worn or damaged parts. Replace worn parts as necessary or contact
an authorised service centre for repair before using the product again.
General cleaning
> Clean the product with a dry cloth. Use a brush for areas that are hard to
reach.
> In particular clean the air vents (13) after every use with a cloth and brush.
> Remove stubborn dirt with high pressure air (max. 3 bars).
WARNING! Always switch the product off, disconnect the product
from the power supply and let the product cool down before
performing inspection, maintenance and cleaning work!
> Keep the product clean. Remove debris from it after each use and before
storage.
> Regular and proper cleaning will help ensure safe use and prolong the life of
the product.
> Inspect the product before each use for worn and damaged parts. Do not
WARNING! Only perform repairs and maintenance work according to
specialist!
To Next Page
Loading...
