Getting started...
EN
24
In more detail...
Care and maintenance
Repair
This product does not contain any parts that can be repaired by the consumer.
checked and repaired.
There are no spare parts available for this product. Contact an authorised
dealer or through our customer service for more information.
Power cord
If the power cord is damaged, it must be replaced by the manufacturer, its
UK plug
Should the fuse require replacement, it must be replaced with a fuse rated at
IMPORTANT: The wires in the
13
mains lead are coloured in accordance with the
following code:
Blue – Neutral
Brown – Live
Green/Yellow – Earth
4/19/17 4:36 PM
EN
TTB797CPR
by TITAN
13
NOTE: Internal inspection of cylinder. It is important that the internal
surface of the cylinder is inspected every 5 years to check that there
is no corrosion present. Corrosion can lead to weakening of the
cylinder and my cause a danger to the user. This inspection needs
to be carried out by a specialist engineer.
> Place a suitable container under the pressure vessel (6) and unscrew the drain
valve (10) from the drainage opening (Fig.9 ).
> Once the water stops dripping, screw the drain valve back in place to close the
pressure vessel. Dispose of the condensate properly, according to local
regulations.
6
10
Fig. 9
To Next Page
Loading...
