EN
19
In more detail...
TTB820GGT by TITAN
Intended use
Auxiliary handle adjustment
This electric grass trimmer TTB820GGT is designated with a rated power input
of 600 Watts.
The product is intended for cutting weed, grass or similar soft vegetation in
areas that are hard to reach, e. g. under bushes, on slopes and edges. It may
not be used to work on unusual thick, dry or wet grass, e. g. pasture grass, or
to shred leaves.
For safety reasons it is essential to read the entire instruction manual before
rst operation and to observe all the instructions therein.
This product is intended for private domestic use only, not for any commercial
trade use. It must not be used for any purposes other than those described.
Adjust the angle of the auxiliary handle (15)
to t the intended application.
1. Press down the lock button (15a) and
hold it in position, then rotate the auxiliary
handle (15) upward or downward to adjust
the angle (Fig. 6).
2. Release the lock button (15a), and continue
to gently swing the auxiliary handle (15)
until it locks in place. Ensure the tooth
system locks in place.
Length adjustment
Adjust the pole length to t the body height.
1. Loosen the locking sleeve (8) in clockwise
(Fig. 7, step 1).
2. Pull the lower pole (9) out or push it together
to adjust the desired length (Fig. 7, step 2).
3. Tighten the locking sleeve (8) in anticlockwise
(Fig. 7, step 3).
Product functions
2.
1.
15
15a
Fig. 6
9
8
3.
2.
1.
Fig. 7
To Next Page
Loading...
Need help?
General
