EN
32
In more detail...
TTB820GGT by TITAN
Troubleshooting
Troubleshooting
Suspected malfunctions are often due to causes that the users can x themselves.
Therefore check the product using this section. In most cases the problem can
be solved quickly.
WARNING! Only perform the steps described within these
instructions! All further inspection, maintenance and repair work must
be performed by an authorised service centre or a similarly qualied
specialist if you cannot solve the problem yourself!
Problem Possible cause Solution
1. Product does
not start
1.1. Not connected to
power supply
1.2. Power cord or plug is
defective
1.3. Other electrical defect
to the product
1.1. Connect to power
supply
1.2. Check by a specialist
electrician
1.3. Check by a specialist
electrician
2. Product does
not reach full
power
2.1. Extension cord not
suitable for operation
with this product
2.2. Power source
(e.g. generator) has
too low voltage
2.3. Air vents are blocked
2.1. Use a proper
extension cord
2.2. Connect to another
power source
2.3. Clean the air vents
3. Unsatisfactory
result
3.1. Trimming line is worn
damaged
3.1. Replace with a new
one
4. Excessive
vibration or
noise
4.1. Trimmer head is
damaged
4.2. Bolts/nuts are loose
4.3. Trimming line is worn/
damaged
4.1. Replace with a new
one
4.2. Tighten bolts/nuts
4.3. Replace with a new
one
To Next Page
Loading...
Need help?
General
