08
TTB892MLT
Safety information
EN
Safety warnings
>Do not touch the moving tool attachment.
>Do not scrape wet or dampened materials (e. g.
wallpaper) or on moist surfaces. Penetration of water
into the product increases the risk of an electric shock.
>Where possible, secure smaller workpieces to prevent
them from moving under the product.
>Only use tool attachments in good condition. Do not use
them if they are torn or worn.
>Exercise extreme caution when handling the scraper.
The scraper is sharp; danger of injury.
>Keep your hands away from the cutting area. Do not
reach under the material being cut.
>Hold power tool by insulated gripping surfaces, when
performing an operation where the cutting accessory may
contact hidden wiring or its own cord. Cutting accessory
contacting a “live” wire may make exposed metal parts
of the power tool “live” and could give the operator an
electric shock.
>Clamping surfaces shall be cleaned to remove dirt,
grease, oil and water.
>Longer period using may lead overheating blade tips.
Therefore take breaks of approx. 15 minutes on a regular
basis to let the blade tips cool down.
>The power tool shall not be wet or applied in wet
environment.
>The voltage of the power source must agree with the
>Check the product, its power cord and plug as well as
accessories for damage before each use. Do not use the
product if it is damaged or shows wear.
>Double check that the accessories and attachments are
condition will be helpful to identify the problems.
To Next Page
Loading...
