TTB892MLT
Getting started...
EN
09
Safety information
>Secure the workpiece. A workpiece clamped with
clamping devices or in a vice is held more secure than
by hand.
>Keep the handles dry to ensure safe control. Grip the
product securely with two hands so you have full control
at all times.
>Ensure that the air vents are always unobstructed and
clear. Clean them if necessary with a soft brush. Blocked
air vents may lead to overheating and damage the
product.
>Switch the product off immediately if you are disturbed
while working by other people entering the working area.
Always let the product come to complete stop before
putting it down.
>Do not overwork yourself. Take regular breaks to ensure
you can concentrate on the work and have full control
over the product.
>Always keep the power cord behind the power tool.
Vibration and noise reduction
To reduce the impact of noise and vibration emission,
limit the time of operation, use low-vibration and
low-noise operating modes as well as wear personal
protective equipment.
Take the following points into account to minimise the
vibration and noise exposure risks:
>Only use the product as intended by its design and these
instructions.
>Ensure that the product is in good condition and well
maintained.
>Use correct cutting attachments for the product and
ensure they are in good condition.
>Keep tight grip on the handles / gripping surface.
>Maintain this product in accordance with these instructions
and keep it well lubricated (where appropriate).
To Next Page
Loading...
