Safety information
12
Safety information
h) Do not place any object on top of the power adaptor
as it could cause overheating. Do not place the power
adaptor near any heat source.
i) Do not use the power adaptor if it has been subjected to
a heavy knock, dropped or otherwise damaged in any
way. Have the power adaptor checked and repaired
by an authorised service centre.
j) Do not disassemble the power adaptor. Incorrect re-
assembly may result in the risk of re, electric shock
or electrocution.
k) To reduce the risk of damage to the charger cable
and plug, always pull the plug rather than the charger
cable when disconnecting the power adaptor from
power supply.
Additional safety warnings for built-in battery
a) Battery needs to be charged before use. Always
refer to the power adaptor’s instruction and charge it
properly.
b) Remove the USB charger cable from the product
after the nish of charging.
c) Don’t maintain the battery on the charger when
not in use.
d) After extended periods of storage, it may be
necessary to charge and discharge the battery
several times to obtain the maximum performance.
e) Longer life and better performance can be obtained
if the battery is charged when the air temperature
is between 18 °C and 24 °C. Do not charge the
battery in air temperature below 5 °C or above 40 °C.
This is important as it can prevent serious damage to
the battery.
MNL_3.6 V Cordless 12mm Stapler_V2_230628.indd 12 6/28/23 5:43 PM
To Next Page
Loading...
