Titan TTB960STP - Troubleshooting

EN
32
EN
Troubleshooting
In more detail...
TTB960STP by TITAN
Troubleshooting
Suspected malfunctions are often due to causes that the users can x themselves.
Therefore check the product using this section. In most cases the problem can
be solved quickly.
WARNING! Only perform the steps described within these instructions!
All further inspection, maintenance and repair work must be performed
by an authorised service centre or a similarly qualied specialist if you
cannot solve the problem yourself!
Problem Possible cause Solution
1. Product does
not start
1.1. Built-in battery is discharged 1.1. Charge it
1.2. Built-in battery is damaged 1.2. Check by a specialist
electrician
1.3. Battery pack is damaged
1.3. Refer to section
“Operation -> Firing”
1.4. Other electrical defect to
the product
1.4. Check by a specialist
electrician
2. Product does
not reach full
power
2.1. Built-in battery capacity is
too low
2.1. Charge it
2.2. Air vents are blocked 2.2. Clean the air vents
3. Unsatisfac-
tory working
result
3.1. The driven staples are not
ush with the work surface
3.1. The impact force is not
enough for working
material
3.2. Improper staples are used 3.2. Choose suitable size
of the staples
4. The ring
suddenly
stops
4.1. Built-in battery is discharged 4.1. Charge it
4.2. Staple is blocked 4.2. Remove jam
4.3. Magazine (8) is empty 4.3. Rell the magazine (8)
5. Excessive
vibration or
noise
5.1. Bolts/nuts are loose 5.1. Tighten bolts/nuts
MNL_3.6 V Cordless 12mm Stapler_V2_230628.indd 32 6/28/23 5:43 PM