Titan TTCSP49 - Page 24

24
TTCSP49
Getting Started . . .
4. Wipe up spilled saw chain oil with a soft cloth. Ret and screw the oil tank cap (15)
rmly (Fig. 10).
NOTE: Always dispose of used saw chain oil and objects contaminated with
them in accordance with local regulations.
Test run
NOTE: Perform the following test before operating your product. This product
is equipped with an automatic oiling system! The oiling system automatically
delivers the proper amount of oil to the guide bar (2) and saw chain (3).
Checking the lubrication requires starting the engine. Before checking, the
product must be fully assembled and all instructions must have been read.
1. Make sure the guide bar (2) and the saw chain (3) are in place when you check the
oil delivery.
2. Start the engine; keep it running at medium speed and check if the chain oil is
delivered as shown (Fig. 12).
3. Adjust the chain oil ow by turning the chain oil ow adjuster (22) on the bottom of
the product using the screwdriver (28) (Fig. 13).
12
13
22
28
Before you start