EN
21
In more detail...
TTI821GGT by TITAN
Intended use
Auxiliary handle adjustment
This cordless grass trimmer TTI821GGT is designated with a rated voltage of
18 V . It is designed only to be used with the battery pack which is listed in
the chapter of “Technical specications”.
The product is intended for cutting weed, grass or similar soft vegetation in
areas that are hard to reach, e. g. under bushes, on slopes and edges. It may
not be used to work on unusual thick, dry or wet grass, e. g. pasture grass, or
to shred leaves.
For safety reasons it is essential to read the entire instruction manual before
rst operation and to observe all the instructions therein.
This product is intended for private domestic use only, not for any commercial
trade use. It must not be used for any purposes other than those described.
Adjust the angle of the auxiliary handle (15) to t the intended application.
1. Press down the lock button (15a) and hold it in position, then rotate the
auxiliary handle (15) upward or downward to adjust the angle (Fig. 5).
Product functions
15
15a
1.
2.
Fig. 5
2. Release the lock button (15a), and continue to gently swing the auxiliary
handle (15) until it locks in place. Ensure the tooth system locks in place.
Auxiliary handle adjustment
Adjust the pole length to t the body height.
1. Loosen the locking sleeve (8) in clockwise (Fig. 6, step 1).
2. Pull the lower pole (9) out or push it together to adjust the desired length (Fig.
6, step 2).
3. Tighten the locking sleeve (8) in anticlockwise (Fig. 6, step 3).
To Next Page
Loading...
Need help?
General
