EN
33
In more detail...
TTI821GGT by TITAN
Care and maintenance
/
Troubleshooting
5. Always store the product in a place that is inaccessible to children. The ideal
storage temperature is between 10 °C and 30 °C.
6. We recommend using the original package for storage or covering the product
with a suitable cloth or enclosure to protect it against dust.
Transportation
1. Switch the product off and remove the battery pack.
2. Attach the knife protector (11d) if necessary.
3. Push the plant protector (12) in if necessary.
4. Always carry the product by its handles (1, 15).
5. Protect the product from any heavy impact or strong vibrations which may
occur during transportation in vehicles.
6. Secure the product to prevent it from slipping or falling over
Troubleshooting
Suspected malfunctions are often due to causes that the users can x
themselves.
Therefore check the product using this section. In most cases the problem can
be solved quickly.
WARNING! Only perform the steps described within these instructions!
All further inspection, maintenance and repair work must be performed
by an authorised service centre or a similarly qualied specialist if you
cannot solve the problem yourself!
Problem Possible cause Solution
1. Product does
not start
1.1. Battery pack not
properly attached
1.2. Battery packdischarged
1.3. Battery pack damaged
1.4. Other electrical defect
to the product
1.1. Attach properly
1.2. Remove and charge
battery pack
1.3. Replace with a new
one of the same type
1.4. Check by a specialist
electrician
2. Product does
not reach full
power
2.1. Battery pack capacity
too low
2.2. Fan opening is blocked
2.1. Charge battery pack
2.2 Clean the fan opening
3. Unsatisfactory
result
3.1. Trimming line is worn /
damaged
3.1. Replace with a new
one
To Next Page
Loading...
Need help?
General
