Titan TTI932CHN - Page 46

46
In
more
detail...
EN
TTI932CHN
Sharpening
angle 25°
Left-hand
cutter
File
direction
Outside
Inside
Saw chain direction
Fig. 43
6. File each tooth from the inside towards outside only. File one side of the
chain rst than turn the saw around and repeat the process.
7. Sharpen each tooth equally by using the same number of strokes.
8. Keep all cutter lengths equal. Check the safety depth gauge height every
5 sharpenings. If the depth gauges are also trimmed it is essential that the
original prole be restored.
9. Use a depth gauge measuring instrument to check the height of the depth
gauge. Depth gauge measuring jigs are available from most reputable tool
merchants (Fig. 44).
Top plate
Cutting tip
File position
Depth gauge
Depth gauge
setting 0,025”
Cutter
length
Fig. 44
Repair
This product does not contain any parts that can be repaired by the consumer.
Contact an authorised service centre or a similarly qualied person to have it
checked and repaired.
Storage
1. Switch the product off and remove the battery pack.
2. Clean the product as described above.
3. Attach the guide bar cover (22) to the saw chain (11) if necessary.
4. Store the product and its accessories in a dark, dry, frost-free, well-
ventilated place.
5. Always store the product in a place that is inaccessible to children. The
Care and maintenance