Titan TTL758CHN User Manual

36
TTL758CHN
In
more
detail...
EN
Operation
3. When the log is supported
on both ends (Fig. 12c), cut
1/3 the diameter from the top
(overbuck). Then make the
nished cut by underbucking
the lower 2/3 to meet the rst
cut.
4. When bucking on a slope
always stand on the uphill
side of the log (Fig. 12d).
When “cutting through”, to
maintain complete control
release the cutting pressure
near the end of the cut
without relaxing your grip on
the product handles. Don’t let
the chain contact the ground.
After completing the cut, wait
for the saw chain to stop
before you move the product.
Always stop the motor before
moving from tree to tree.
5. Support small logs on a
sawing stand or another log
while bucking (Fig. 12e).
Fig. 12c
Fig. 12d
Fig. 12e

Titan TTL758CHN Specifications

General

Engine Type	2-stroke
Engine Displacement	58cc
Bar Length	20 inches
Fuel Tank Capacity	550 ml
Oil Tank Capacity	260 ml
Power Source	Petrol
Chain Speed	21 m/s
Guide Bar Length	20 inches
Chain Pitch	0.325 inches
Chain Gauge	0.058 inches