44
TTL758CHN
In
more
detail...
EN
Care and maintenance
Plug replacement (for UK only)
If you need to replace the tted plug, then follow the instructions
below.
IMPORTANT: The wires in the mains lead are coloured in
accordance with the following code:
Blue – Neutral Brown – Live
As the colours of the wire in the mains lead of this product may not
correspond with the coloured marking identifying the terminals in
your plug, proceed as follows. The wire, which is coloured blue, must
be connected to the terminal, which is marked with N or coloured
black. The wire, which is coloured brown, must be connected to the
terminal, which is marked L or coloured red.
Only t an approved 13 Amp BS 1363 or BS 1363/A plug and the
correctly rated fuse. If in doubt, consult a qualied electrician.
13 AMP fuse approved
to BS 1362
Brown L
(Live)
Cable grip
Outer sleeve
rmly clamped
Connect
Blue to N
(Neutral)
WARNING! Never connect live or neutral wires to the earth
terminal of the plug, which is marked with E.
NOTE: If a moulded plug is tted and has to be removed
take great care in disposing of the plug and severed cable, it
must be destroyed to prevent engaging into a socket.
If the power cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in order
to avoid a safety hazard
Power cord
To Next Page
Loading...
Need help?
General
