Titanium MIG140 - Front Panel Controls; Understanding Welder Controls

Page 16 @)1&/2:(+.:4=&A02'/.)+'B&6=24'2&:4==&CD###DE#FDFEC#, Item 57863 57864
GH@<IJ KHLMI<MHMN<OHGLN&P<QRLMS P<QRLMS&ILTGG<IUT
@1)+/&T4+2=&N)+/1)='
H=41;&L+>.:4/)15 Lights up if there
is a problem with welder operation.
See Alarm Indicator Error Codes on page 28.
P.12&G622>&Z+)35 Controls the speed that the
welding wire feeds out of the MIG Gun or Spool
Gun and the output amperage of the Welder.
KLS Gun / Spool Gun Cable Socket5&The MIG Gun
and Spool Gun Cables connect here. The wire,
welding current, and shielding gas (if performing MIG)
feed to the welding gun through here.
P.12&@22>&N)+/1)=&G):]2/5 Connect the
Wire Feed Control Cable here.
-)=/492&Z+)35 This controls the output voltage.
L+>0:/4+:2&Z+)35 This controls the output inductance.
bI7%I&G*./:(5 Use this to set the Gun Trigger
operation to either 2T or 4T mode:
2T (2 touch) mode:
1. Squeeze the trigger to start the welding current.
2. Release trigger to stop the welding current.
4T (4 touch) mode:
1. Squeeze trigger to start welding.
2. Release trigger during welding.
3. Squeeze and release trigger to
shut welding current off.
P.12&
G622>&
Z+)3
L+>0:/4+:2&
Z+)3
bI&7&%I&
G*./:(
-)=/492&
Z+)3
KLS&S0+&7&
G6))=&S0+&
N43=2&G):]2/&
P.12&@22>&
T)*21&N43=2
H=41;&
L+>.:4/)1
P)1]&
L+>.:4/)1
T)*21&
L+>.:4/)1
P.12&@22>&
N)+/1)=&G):]2/
T)'./.Y2&
I21;.+4=
M294/.Y2&
I21;.+4=