Replacing your Cogeco
TiVo Mini Receiver
3
Activating your TiVo Mini
After connecting your TiVo Mini to your TV, please use your existing TiVo remote to follow these simple instructions
to activate your receiver.
1. On the welcome screen, use the UP and DOWN arrows
on the TiVo remote, then SELECT to choose your country.
2. Select your preferred language.
3. Use the SELECT button to choose
“Begin Guided Setup for Canada”.
.
4. Choose Network hookup: select MoCA connection.
5. Select Continue.
6. IP Address - select “Get automatically from a DHCP
server (typical)”.
2
Connecting your TiVo Mini
ANTENNA/
RF IN
HDMIDVI
HDTV
CABLE INPUT
POWER
CORD
CB
D
A
A. Connect the coaxial cable from your wall to the MoCA input of your
TiVo Mini.
C. Connect the power cord of the TiVo Mini to an active wall power outlet.
B. Connect the HDMI output of the TiVo Mini to the HDMI input on your HDTV
using the HDMI cable provided.
D. Note the name of the HDMI input on your TV that is connected to the
TiVo Mini (ex. HDMI-1).
E. Press the INPUT or SOURCE button on your TV's remote control and select
the video input that connects your TV to your TiVo Mini. When you see TiVo
Welcome screen, you are ready to start the activation process.
Record the TiVo service number (TSN) and MAC address of your new
TiVo Mini (found underneath the receiver). You may require these numbers
in the event where troubleshooting with technical support is needed.
TiVo service no.
MAC address.
1
Removing your old equipment
B. Unplug the power supply from the electrical outlet and the back of the receiver.
A. Disconnect your existing TiVo Mini receiver. Begin by unplugging the coax from the back of the receiver.
C. Unplug the cables connecting the receiver to the television.
For more support information visit cogeco.ca/Tivosupport
To Next Page
Need help?
General
