TKOKO M-5060 - Connections

To Next Page

To Previous Page

Setups

Choose input wire and connectors

For the amplifier output connectors,TKOKO recommends using pre-built or professionally wired,

high-quality, and heavy gauge speaker wires.You may use screw terminal for your output connec-

tors.To prevent the possibility of short-circuits, wrap or otherwise insulate exposed loudspeaker

cable connectors.

Using the guidelines below, select the appropriate size wire based on the distance from amplifier

to speaker. The wire sizes apply to the 4-ohm tap.

Distance Wire Size

Up to 25 ft. 16 AWG

26~40 ft. 14 AWG

41~60 ft. 12 AWG

61~100 ft. 10 AWG

101~150 ft. 8 AWG

151~200 ft. 6 AWG

NOTE: Custom wiring shoule only be performed by qualified personnel. Class 2 wiring is re-

quired.

CAUTION: Never use shielded cable for output power wiring

Figure shows connector pin assignments for wiring

[Connection to speakers illustration ]

Hi-Z

Lo-Z

M-5060/M-5120/M-5240/M-5300