TKSTAR TK905 - SMS Configuration; Admin Number Setting; Over-speed Alarm Setting; Shake Alarm Setting

INDICATOR LIGHT STATUS
MEANING
Yellow light -Solid
No GPRS signal
Yellow light -Flash
GPRS connection
Blue light -Solid
No GPS signal
Blue light -Flash
GPS connection
4.
SMS Configuration
4.1. Admin number setting (After admin number setting, all SMS operations to the device are under this number
only.)
Command: admin123456 phone number（This phone number is your own mobile phone number , not the
SIM card number in tracker .）
Reply：
admin ok
E.g：admin123456 13265790180
When the unit is in over-speed alarm, shake sensor alarm, or low battery alarm, it will send alert to the admin
number.（13265790180）
Admin number Canceling:
Command ：noadmin123456
Reply：noadmin ok
4.3. Over-speed Alarm setting（It works only in continuous positioning mode.）
Over-speed Alarm setting:
Command ：speed123456 070（Suppose speed is 70km/h）
Reply：speed ok
E.g：
When the unit speed is over 70km/h, it will send message “speed alarm!” to the admin number every 5
minutes.
Over-speed Alarm canceling ：
Command ：nospeed123456
Reply：nospeed ok
4.4. Shake Alarm setting
Command：vib3,3