TLV Trapman - TM6 Preparation and Setup; Inserting Batteries; Powering the Device On and Off

RN070405A_TM6Manual_01E.doc
6
4. TM6 Preparation
4.1 Inserting Batteries
1) Turn the battery compartment lock counterclockwise to unlock.
2) Open the battery compartment and remove the battery pack (battery
compartment cover).
3) Insert 2 batteries into the battery pack. Make sure the batteries have the correct
orientation (polarity).
4) Reattach the battery pack and close the battery compartment.
5) Turn the battery compartment lock clockwise to lock.
Locked Position Unlocked Position Battery Pack
CAUTION
When not intending to use for an extended period of time, remove the
batteries from the unit. Failure to do so could result in battery fluid leakage.
4.2 Turning the Power ON/OFF
1) Press [ENT] to turn TM6 on. The initial screen will appear on the display after 2
seconds
2) Press and hold the [ENT] key for 2 seconds to turn TM6 off.
4.3 Attaching and Removing the Cap
1) To remove the cap, twist 45° counterclockwise and take off.
2) To attach, place the cap over the probe and twist 45°clockwise to close.
Turn Counter-
clockwise to
Unlock
Turn
Clockwise
to Lock