To Next PageTo Next Page
Need help?Do you have a question about the Toa A-2120 SA and is the answer not in the manual?
General| Power Output | 120W |
|---|---|
| Rated Output | 120W |
| Muting | MIC 1: Mutes other input signals by 0 - 30 dB attenuation |
| Indicator | Power, Signal, Peak |
| Total Harmonic Distortion | Under 1% |
| Signal to Noise Ratio | 60dB |
| Power Source | AC 220 - 240 V, 50/60 Hz |
| Input | Mic x 4, AUX x 2 |
| Tone Control | Bass: ±10 dB at 100 Hz, Treble: ±10 dB at 10 kHz |
| Operating Temperature | -10°C to +40°C |
| Finish | Panel: ABS resin, black/Case: Steel plate, black |
| Input Impedance | Mic: 600 Ω, Aux: 10 kΩ |
| Output Impedance | 4 Ω |
| Input Sensitivity | Mic: -60 dB, Aux: -20 dB |
| Output | Speaker Output (Terminal Block) |
Explains symbols like exclamation point and WARNING for potential hazards and proper use.
Precautions for installation, avoiding rain, using specified voltage, cord handling, and unstable locations.
Identifies and describes front panel controls and indicators like Power Switch, Volume Controls, and signal indicators.
Identifies and describes rear panel connections and terminals like Output Terminals, Input Jacks, and Ground Terminal.
Details on connecting microphones (dynamic, phantom power) and AUX sources using phone and RCA jacks.
Explains how to connect low impedance, 70V, and 100V line speakers, including safety cautions.
Provides diagrams showing connections for microphones, tuners, cassette players, and speakers.
