Why is there no audio output from the local speaker when using Local Broadcasting on Toa IP-A1PG?
If OFF, the audio input will be directed toward the network, so no audio will be output from the local speaker.
What type of control signal should be input to Toa Speakers?
Input a no-voltage signal.
How long should the control signal input be for Toa IP-A1PG?
Be sure that the signal is input for at least 200ms.
How to verify the remote API command being transmitted to Toa Speakers?
Check that the URI of the transmitted command is correct.
How to appropriately set the gain for the equipment connected to the LINE/MIC IN terminals of Toa IP-A1PG Speakers?
Set the device’s gain with the DIP switch, depending on the type of equipment connected to the LINE/MIC IN terminals.
General| Total Harmonic Distortion | Less than 5% |
|---|---|
| Operating Temperature | -10°C to +50°C |
| Power Output/Handling | 10W |
| Power Source | PoE (Power over Ethernet) |
| S/N Ratio | More than 60 dB |
| Finish | ABS resin |
| Material | ABS resin |
To Next Page
