Pro Fusion User Manual v.2.2 18
adhesive that doesn’t damage the underlying surface when the bracket is removed. For more inform-
ation, read Detach the eye tracker.
If the screen bezel is thinner than the height of the eye tracker, affix the mounting bracket
as low as possible on the screen frame, or directly on the screen. Don’t use this setup if
you intend to put stimuli in the lower part of the screen, as they might become covered by
the eye tracker.
Some laptops are very thin and there is little space between the screen and the keyboard
when the laptop is closed. We recommend that you check whether the laptop can close
with the mounting bracket present
before
you attach it.
What to do:
1. Make sure the eye tracker is attached to the monitor and connected to your computer. Open
Pro Eye Tracker Manager. You should be able to see and expand your eye tracker’s “card” in
Pro Eye Tracker Manager. The serial number of your eye tracker should match the number
displayed.
2. You can leave your eye tracker USB cable connected with the eye tracker to the side (for
example on the table)
or
you can disconnect it while you attach the mounting bracket.
3. If you plan to attach the eye tracker to a laptop, make sure the laptop can close with the mag-
netic mounting bracket attached. Some laptops have very little space when closed.
You can test whether you can close the laptop with the mounting bracket by placing the
mounting bracket (with the backing paper still attached) on the keyboard side of the
laptop and carefully closing the laptop lid. Watch for any potential interference between
the screen, bracket, and keyboard.
4. Find the center of the screen and clean the bezel with one of the included cleaning wipes.
5. Peel the adhesive tape off the mounting bracket and mount it on the bezel so that your Pro
Fusion is as close to the bottom of the screen as possible without covering the screen. Press
the bracket against the bezel for 30 seconds and wait one hour before attaching the eye
tracker.
To Next Page
Loading...