SECTION 4
4-22
3-/ 4-Cylinder
Installation
WARNING
Ignition system must be disabled to prevent
accidental engine startup during installation of
the flywheel.
1. Remove all grease from crankshaft threads and tapered portion
of flywheel with solvent.
2. Check flywheel key is inserted in crankshaft.
3. Align flywheel keyway and install on crankshaft. Install the flywheel
washer.
4. Install puller
(1)
on flywheel using bolts
(2)
. Hold puller
handle and torque flywheel nut to specification.
5.Install recoil starter or flywheel cover as required.
Model
Flywheel Nut Torque
ft-lb
N·m
kg-m
40 / 50
65.1 - 79.5
88.2 - 107.8
9.0 - 11.0
60 / 70 / 80 / 90
101.2 - 115.7
137.2 - 156.8
14.0 - 16.0
115 / 120 / 140
181.0 - 195.0
245.0 - 264.6
25.0 - 27.0
7
8
T1199
T1198
To Next Page
