[Break- in]
Install test propeller (confirm to no free gap on the test propeller on the drive shaft.)
You must do break-in the engine by operating it for initial 10hours with mixing ratio by 25:1.
エラー!
When installing an outboard motor on a test tank, secure tighten bolts and fix to transom.
It tames and operation gives the familiarity nature of the inside parts of engine.
It is quite important procedure to extend the long term of the usage.
Please be sure to perform first time operation according to the owner's manual.
It makes a test run and each operation situation is checked.
Refer to the PDI sheet for each part check points.
It becomes the delivery to a customer after all operation checked.
*Necessity of the PDI
The outboard motors of Tohatsu are produced in a factory and confirm each adjustment by driving
before shipment.
Temperature or the humidity is different globally by a country and an area. The check before shipping
an outboard motor is necessary for these different places.
Naturally, the factory shipment is not done in a state to meet all countries and the area.
In addition,
need to confirm if damage is not happen or not.
It is necessary to perform PDI before it is delivered an outboard motor to a customer by distributor
and/or dealers.
To Next Page
Loading...
