TOHATSU MFS 25C - General Safety Information; Stop Switch Lanyard Use

vi
4st 25/30 2016
6) Inspection of Brushes ……………………… 8-22
7) Inspection of Starter Motor Operation …… 8-22
ÇÊ >ÌÌiÀÞÊ>À}}Ê-ÞÃÌiÊ oooo Ê8-23
1) Inspection of Alternator …………………… 8-23
2) Inspection of Rectifier ……………………… 8-23
nÊ 1ÊÕ«iÀÊoooooooooooo Ê8-24
°/ÀÕLiÃÌ}
£Ê /ÀÕLiÃÌ}ÊÃÌÊ ooooooo Ê9-2
ÓÊ *ÜiÀÊ1ÌÊooooooooooooo Ê9-3
State 1 : Engine will not start or is a little hard to start. 9-3
Starting System ……………………………… 9-3
Ignition System ……………………………… 9-5
Fuel System ………………………………… 9-7
State 2 : Full throttle engine revolution speed is low.
Engine revolution speed fall off.Engine stalls … 9-9
Ignition System ……………………………… 9-10
Fuel System ………………………………… 9-11
Lubrication System ………………………… 9-12
Cooling System ……………………………… 9-13
State 3 : Engine rotation is unstable or hunting occurs
in low speed range. ……………………… 9-14
Ignition System ……………………………… 9-15
Fuel System ………………………………… 9-16
ÎÊ *//Ê1ÌÊ oooooooooooooo 9-17
State 1 : PTT will not operate. ………………… 9-17
State 2 : PTT is not capable of sustaining outboard motor. 9-18
{Ê >}ÃÃÊ ooooooooooo Ê9-19
1.Set Up ………………………………………… 9-19
1) Diagnosis Software Install ……………… 9-20
2) Installing USB to serial converter
driver (If there is no RS232 port) ……… 9-21
2.Hardware Connection …………………… 9-22
1) Preparation ……………………………… 9-22
2) Position of ON/OFF switch for function test
 and running (drop) test …………………… 9-23
3.Operating Procedure ……………………… 9-24
1) Start Up …………………………………… 9-24
2) Models and Menu Selection …………… 9-24
3) Preface and Introducion ………………… 9-24
4) Setting Communication (COM) Port …… 9-25
5) Engine Monitor …………………………… 9-27
6) Diagnostic History ……………………… 9-28
7) At Engine Shut-down Test ……………… 9-29
8) At Engine Running Test ………………… 9-30
9) Explanation of Error code ……………… 9-31
10) Exit Diagnostic ………………………… 9-31
£ä°VViÃÃÀiÃ
£Ê ,iÌiÊÌÀÊ«iÌÃÊo Ê10-2
1)
Installation of Remote Control Cable (Engine Side)
Remote Control Model ……………………… 10-2
ÓÊ ÃÌ>>ÌÊvÊiÌiÀÃÊ>`Ê>ÌÌiÀÞ ÊÊ10-5
1) Installation of Meters ………………… 10-5
2) Installation of Battery ………………… 10-5
3)
Wiring Diagram of Remote and Control Meters 10-6
ÎÊ "«iÀ>ÌÊoooooooooooo Ê10-7
1) Warning Indication …………………… 10-7
££°7À}Ê>}À>
7À}Ê>ÀÌÊooooooooooo Ê11-2
ÉÊ>}ÊiÌiÀ®Êooooo Ê11-3
ÉÉ/Ê>}ÊiÌiÀ®Êooo Ê11-5
ÉÊ}Ì>ÊiÌiÀ®Ê ooooo Ê11-7
ÉÉ/Ê}Ì>ÊiÌiÀ®Ê ooo Ê11-9
É/Ê>}ÊiÌiÀ®Ê ooooo Ê11-11
É*É*/Ê>}ÊiÌiÀ®Êooo Ê11-13
É/Ê}Ì>ÊiÌiÀ®Ê ooooo Ê11-15
*É*/Ê}Ì>ÊiÌiÀ®Ê ooooo Ê11-17