PRE-OPERATING PREPARATIONS 29
ENOM00038-0
Your new outboard motor and lower unit
require break-in for the moving compo-
nents according to the conditions
described in the following time table.
ENOW00023-0
Operating the outboard motor without
break-in can shorten service life of the
product.
If any abnormality is experienced during
the break-in:
Discontinue the operation immediately.
Have the dealer check the product and
take proper action(s) if necessary.
ENON00008-0
Note
Proper break-in allows outboard motor to
deliver it full performance for longer service
life.
ENOW00024-0
Do not operate the outboard motor in
closed area or area with no forced ventila-
tion.
Exhaust gas emitted by this outboard
motor contains carbon monoxide that will
cause death if inhaled continuously. Inhal-
ing the gas initially causes symptoms such
as feeling of sickness, drowsiness and
headache.
During operation of the outboard motor:
Keep peripheral area well ventilated.
Always attempt to stay on the windward
side of emission.
6. Break-In
CAUTION
1–10 min 10 min – 2 hrs 2–3 hrs 3–10 hrs After 10 hrs
Throttle Position Idle
Less than 1/2
throttle
Less than 3/4
throttle
3/4 throttle
Full throttle
available
Speed
Approx. 3000
rpm max
Full throttle run
allowed for 1
min every 10 min
Approx. 4000
rpm. Full throttle
run allowed for 2
min every 10 min
DANGER
MFS25-30B_EN.book Page 29 Wednesday, December 12, 2012 11:58 AM
To Next Page
Loading...
Need help?
General
