PRE-OPERATING PREPARATIONS 35
6
Remedy
1.
Reduce the throttle to less than half
opening, and move to safe place
quickly, and stop the engine.
Check the propeller for bent or dam-
aged blades.
Consult an authorized dealer if engine
shows the same result even after
replacing propeller with new one.
2.
Move to safe place quickly, and stop
the engine.
Check the engine oil level, and add
engine oil if necessary.
Consult your dealer if the engine oil
level is too low or too high.
3.
Move to safe place quickly, and check
the discharge of cooling water from
the water check port at idle speed
and stop engine.
Remove any foreign matter on the
gear case and propeller if necessary.
Consult an authorized dealer if no
discharge of cooling water.
4.
Consult an authorized dealer.
ENOW00025-A
z Low speed ESG ON: Engine speed will be
limited to 2800 min
-1
(rpm), however you
should not continue to run engine.
z High speed ESG ON: Engine speed will be
limited to 6300 min
-1
(rpm) and engine
will run rough until throttle is reduced.
CAUTION
To Next Page
Loading...
Need help?
General
