ENGINE OPERATION 41
7
ENOW00032-1
Do not hold turning starter motor more than
5 seconds, or the battery may be consumed,
potentially making the engine starting
impossible and/or damaging the starter.
If cranking over 5 seconds fails to start
engine, return main switch to “ON”, and
crank engine again after 10 seconds or more.
7. Check the cooling water from cool-
ing water check port.
Side mount RC type
1. Be sure to install the stop switch lock
to the stop switch, and attach the
stop switch lanyard securely to the
operator or to the operator's PFD
(Personal Flotation Device.)
1. Stop switch lock
2. Insert the main switch key.
3. Set the control lever in the Neutral
position. Do not raise the free throt-
tle lever when starting the engine.
1. Neutral (N)
2. Control lever
3. Fully opened (Forward)
4. Fully opened (Reverse)
5. Free throttle lever
6. Main switch key
7. Stop switch
4. Turn the main switch key to ON posi-
tion and confirm warning lamp light
up with buzzer sound and then go off.
1. Warning lamp
5. Turn the main switch key to START
position and release the key when the
engine has started. The key returns to
the original position, automatically.
CAUTION
ENOF00868-0
N
R
F
1
2
3
4
5
6
7
ENOF00870-1
1
ENOF00851-A
To Next Page
Loading...
Need help?
General
