EasyManuals Logo

TOHATSU MFS 40A User Manual

TOHATSU MFS 40A
98 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #71 background imageLoading...
Page #71 background image
INSPECTION AND MAINTENANCE 71
10
*1: Have this handled by your dealer.
*2: In USA, you have to use EPA approved part (See pages 37).
ENON00030-0
Note
Your outboard motor should receive careful, and complete inspection at 300 hours. This is the
best time for major maintenance procedures to be carried out.
ENOM00091-A
Engine oil replacement
ENOW00091-0
You may be injured due to high engine tem-
peratures if you fill engine oil just after stop-
ping. Changing engine oil should be done
after the engine has been cooled.
ENOW00092-A
z Do not overfill engine oil, or engine oil
could leak and/or engine could be dam-
aged. If engine oil level is over upper limit
marks of oil gauge, drain oil to level lower
than upper limit.
z Be sure that outboard motor is in upright
and level position when checking or
changing oil.
z Stop engine immediately if low oil pres-
sure warning lamp is lit or oil leak is found,
or engine could be severely damaged.
Consult dealer.
z Wipe off engine oil well immediately if
spilled and dispose of it in accordance
with local fire prevention and environ-
ment protection regulations.
ENOW00090-0
Use of engine oils that do not meet these
requirements will result in reduced engine
life, and other engine problems.
ENOW00933-0
Engine oil mixed with dust or water will dra-
matically shorten the life of the engine.
To change engine oil:
Be sure to use recommended engine oil.
1. Stop the engine and allow it to cool.
2. Tilt up the outboard motor and lock
the tilt with the tilt stopper.
3. Turn the steering on the outboard
motor so that the drain hole is facing
downward.
4. Put a oil drain pan under the oil drain
screw.
5. Remove the oil drain screw and com-
pletely drain oil from the engine.
Bolts and Nuts
zz
Retighten
Sliding and Rotating Parts.
Grease Nipples
zz
Apply and pump in grease. (See
page 81)
Outer Equipment
zz
Check for corrosion.
Anode
z
Check for corrosion and deformation. Replace if
necessary.
Description
Inspection intervals
Inspection procedure Remarks
First 20
hours of 1
month
Every 50
hours of 3
months
Every 100
hours of 6
months
Every 200
hours of 1
year
CAUTION
CAUTION
CAUTION
CAUTION

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the TOHATSU MFS 40A and is the answer not in the manual?

TOHATSU MFS 40A Specifications

General IconGeneral
BrandTOHATSU
ModelMFS 40A
CategoryOutboard Motor
LanguageEnglish

Related product manuals