INSPECTION AND MAINTENANCE 73
10
ENOW00925-0
Wipe off engine oil well immediately if spilled
and dispose of it in accordance with local
fire prevention and environment protection
regulations.
ENON00031-0
Note
z If any amount of water is found in
engine oil, making it milky white, consult
dealer.
z If engine oil is contaminated with fuel,
emitting strong fuel smell, consult
dealer.
z Some oil dilution is normal if engine is
idled or trolled for long periods, espe-
cially in cooler water temperatures.
ENOM00092-A
Oil filter replacement
ENOW00091-0
You may be injured due to high engine tem-
peratures if you fill engine oil just after stop-
ping. Changing engine oil should be done
after the engine has been cooled.
ENOW00926-0
Wipe off engine oil well immediately if spilled
and dispose of it in accordance with local
fire prevention and environment protection
regulations.
1. Drain oil from the engine.
2. Place a rag or towel below the oil fil-
ter to absorb any spilled oil.
3. Unscrew old filter by turning the filter
to counter clockwise.
4. Clean the mounting base. Apply film
of clean oil to O-ring.
Do not use grease.
Install oil filter and tighten it to specified
torque by using oil filter wrench.
Oil filter torque:
18 Nm (13 ft
-lb, 1.8 kgf-m)
ENON00028-A
Note
If a torque-wrench is not available when
you are fitting a oil filter, a good estimate
of the correct torque is 3/4 to 1 a turn past
finger-tight. Have the oil filter adjusted to
the correct torque as soon as possible with
a torque-wrench.
1. Oil filter wrench
P/N 3AC-99090-0
P/N 3AC99090M
(US. CANADA Only)
1. Oil filter
2. Fuel filter
CAUTION
CAUTION
CAUTION
1
ENOF00094-0
To Next Page
Loading...
Need help?
General
