Washing outboard motor
If outboard motor is used in salt
water, brackish water or water with a
high acidic level, use fresh water to
remove salt, chemicals or mud from
exterior and cooling water passage
after every cruising or before storing
outboard motor for long time. Before
flushing, remove the propeller and the
forward thrust holder.
■
Use flushing attachment.
①
Remove propeller (refer to Propeller
Replacement). Remove the water
plug from the outboard motor, and
screw in the flushing attachment.
②
Attach a water hose to the flushing
attachment. Turn on the water and
adjust the flow. (Be sure to seal
the water inlet and sub water inlet,
located in the gear case, with
tape.
③
Insert a hose connected to a water
tap into the flushing attachment
and let the water running.
④
Put the shift lever in the neutral
position and start the engine.
⑤
Make sure of cooling water flowing
out of water pump indicator hole
and continue engine running for 3
to 5 minutes.
⑥
Stop the engine and water supply.
Remove the flushing attachment
and tape, and then reinstall the
water plug and the propeller.
45
1
2
3
4
5
6
7
8
9
10
11
12
13
INSPECTION AND MAINTENANCE
Never start or operate the engine
indoors or in any space which is not
well ventilated. Exhaust gas contains
carbon monoxide, a colorless and
odorless gas which can be fatal if
inhaled for any length of time.
Keep engine at idle speed during
flushing.
Do not start engine without removing
propeller, or accidentally turning
propeller could cause personal injury.
Keep cooling water passage free of
clogs, or lack of cooling water flow
could lead to engine overheating,
potentially resulting in engine trouble.
To Next Page
Loading...
Need help?
General
