Replacing gear oil
①
Remove the oil plugs (upper and
lower), and completely drain the
gear oil into a pan.
②
Insert the oil tube nozzle into the
lower oil plug hole, and fill with gear
oil by squeezing the oil tube until oil
flows out of the upper plug hole.
③
Install the upper oil plug, and then
remove oil tube nozzle and install
the lower oil plug.
54
14
13
12
11
10
9
8
7
6
5
4
3
2
1
INSPECTION AND MAINTENANCE
Notes
If water in the oil, giving it a milky
colored appearance. Contact your
dealer.
Notes
Use genuine gear oil or the
recommended one (API GL-5: SAE
#80 to #90).
Required volume: approx. 370 ml.
●
Be sure that outboard motor is secured
to transom or service stand, or
accidental drop or fall of outboard motor
could lead to severe personal injury.
●
Be sure to lock outboard motor if
it is tilted up, or accidental fall of
outboard motor could lead to severe
personal injury.
●
Do not go under outboard motor
tilted up and locked, or accidental
fall of outboard motor could lead to
severe personal injury.
Do not reuse oil plug gasket. Always use
new gasket and tighten oil plug properly
to prevent entry of water into lower unit.
To Next Page
Loading...
Need help?
General
